Pitch; Effect - Alesis QS6.1 Reference Manual

Editing Mixes: Chapter 5
P
ITCH
The Pitch function (press
increments.
Tune Octave (-2 to +2 octaves)
This transposes the ProgramÕs pitch in octave (12 semitones) steps from -2 (transposed down 2
octaves) to +2 (transposed up two octaves).
Semitone (-12 to +12 semitones)
This transposes the ProgramÕs pitch in semitone steps, from -12 (transposed down one octave) to +12
(transposed up one octave).
Note: You can combine these two parameters for an effective transposition range of +/- 3 octaves.
Another Note: You can alter the MIDI note numbers being sent to external devices if Keyboard and
MIDI Out are set to OFF (see KEYBOARD/MIDI, dead ahead). Also, see Part 5: MIDI for more
information.
E
FFECT
The Effect function (press
Mix Mode, you can have only one Effect Patch per Mix, which will be the Effects Patch associated
with one of the Programs used in the Mix.
FX Program Change (On or Off)
This determines whether the Effects settings will change along with its Program, if a MIDI
program change is received on the Effect Channel (see next section). If ON, and a MIDI program
change is received, a new Program will be recalled along with its associated Effect Patch. This,
however, can change the way the other Programs in the Mix sound, since they all share the same
Effects Patch. If you want to recall Programs via MIDI program changes, but also want to continue
using the same Effects Patch, leave this parameter turned OFF.
FX MIDI Channel (1 to 16)
The Effect Channel determines which channel within the Mix will have its ProgramÕs Effect Patch
used by the entire Mix. In other words, when the Effect Channel is set to 3, the Mix will use the
Effect Patch which is contained in the Program assigned to channel 3.
QS6.1 Reference Manual
[ 70 ]) lets you transpose a channelÕs Program in either semitone or octave
[ ])
80 is where you select what Effect Patch will be used by the Mix. In
Page 1
Page 2
Page 1
Page 2
101