How Ò1 Reverbó Is Arranged - Alesis QS6.1 Reference Manual

At first glance this diagram may look a little daunting, but if you take a moment to
trace the lines and read the component captions, things will become clear.
Think of it as a kind of Òroad mapÓ charting your audio signalÕs progress from
starting point through to its ultimate destination Ñ the [LEFT] and [RIGHT] outputs
shown at the top of the page.
1) The dotted lines indicate the divisions between different functional blocks.
2) The solid lines indicate signal paths between the blocks and controls.
3) In general, signal flow moves from left to right.
4) The number next to each function name represents one of the four effect sends.
For example, Delay 2 refers to the Delay effect on effect send 2.
HOW "1 REVERB" IS ARRANGED
This Configuration provides three Pitch effects, four Delay effects, and one Reverb
effect, arranged as follows:
1) Sends 1 and 2 can be stereo and have a selectable Pitch effect (Chorus, Flange,
Pitch Detune, or Resonator) followed by a mono or stereo Delay effect.
1) Send 3 offers three possible Pitch effects (Mono Chorus, Mono Flange, or
Resonator) followed by a mono Delay effect.
2) Send 4 is a mono Delay effect only.
3) The single Reverb effect is selected and set in Send 1. Reverb parameters that set
the sound of the reverb itself (such as high and low decay, reverb type, predelay,
etc.) are found only when ÒSend1Ó is displayed. Within this limitation,
however, there is still tremendous flexibility of Reverb routing and control on a
per-Send basis: for example, each of the four Sends has its own controls for
dry/wet ratio, and specific input point. (In Sends 1 through 3 you can take
Reverb inputs from the Send input itself, the output of any Pitch effect, and the
input or output of Delay effect, either individually or in any combination. In
Send 4, the two possible inputs are the input and output of Delay 4.)
4) Each Pitch, Delay and Reverb module has its own independent Mix output level
which controls how much signal is routed directly to the [LEFT MAIN] and
[RIGHT MAIN] outputs. This Mix function is what you use to determine how
much of each Effect component will be heard. Mix 1, for example, is where you
control the outputs of Pitch 1, Delay 1, and Reverb 1 to the main outputs.
The Mix parameter controls how much each Effect block feeds directly to the main outputs. It
does not, however, control how much each block feeds to the blocks that follow it. For example,
when Pitch 1Õs Mix control is set to 0, it is still fully available as an input to Delay 1 and
Reverb 1.
QS6.1 Reference Manual
Part 6: Editing Effects
67