Solenoid Valve Wiring; Connecting The Transformer - Hunter Hydrawise HC Owner's Manual

Solenoid Valve Wiring

1. Take one wire from each solenoid, twist together and connect to the common (usually
white) wire of your multi-conductor irrigation cable.
2. Connect each of the other individual wires to a different colored wire. Record zones
against wire color for later reference.
3. Connect the common wire from the multi-conductor cable (usually white) to any of the
three terminals on the controller marked COMMON.
4. Connect each of the other solenoid wires to one of the ZONE inputs.
5. If a master valve (sometimes labelled as MV on other controllers) is installed this can
be connected to any spare zone as any of the zones can be assigned as a master
valve output. Configuration of the master valve in the Hydrawise app is required.
6. Click the blue wiring cover into place to seal the controller and protect the wiring.

Connecting the Transformer

1. Use the plug pack supplied and connect the wires to the red AC terminal blocks on the
unit marked as 24V. Polarity of the wiring is not important.
2. Turn the power on. The power indicator will light up.
Copyright 2020 Hunter Industries. All Rights Reserved. 7