Table of Contents
Advertisement
RADIO OPERATIONS
TUNER/BAND
POWER
aSET
En
Manual tuning
1 Press TUNER/BAND (BAND on the remote
control) repeatedly to select a band.
The unit switches to the radio from any other function
and alternates between FM and AM.
2 Press f or g repeatedly to tune in a station.
"TUNE" is displayed when a station is tuned in.
"STEREO" is displayed for FM stereo reception.
To search for a station automatically (Auto search)
Hold down f or g.
The unit searches for a station and stops at reception.
To stop the search manually, press f or g.
•Auto search may not stop at stations with weak signals.
10
cPRESET
1
0-9,+10
sCLEAR
BAND
c
f,g
TUNING
DOWN/UP
Preset tuning
Preset up to 32 of your favorite stations and tune them in
directly.
Presetting stations
1 Tune in the desired station.
2 Press a to store the station.
The preset number, beginning from "1" and the "M"
indicator are displayed on the display.
3 Repeat steps 1 and 2 to preset other stations.
•Each band can store a maximum of 16 preset stations.
•If power is interrupted for more than approximately 12 hours,
all settings stored in memory after purchase need to be reset.
Tuning in preset stations
1 Select the band.
2 Press c repeatedly.
With each press, the station with the succeeding preset
number is tuned in.
You can tune in the desired preset station directly by
pressing the numbered buttons on the remote control.
- To select preset number 10, press +10 and 0.
- To select preset number 15, press +10 and 5.
To scan preset stations
MODE
Press "1" until "P-SCAN" is displayed. The preset stations
FUNCTION
are received in ascending order for 5 seconds each. To stop
scanning, press s. The preset number flashes during
a
reception.
f,g
To clear a preset station
s
1 Tune in the station by preset tuning.
2 Press s, then press a within 4 seconds.
Preset station numbers in the band which are higher than
the cleared number decrease by one.
Adjustments
To switch to monaural FM reception
Press MODE on the remote control so that "MONO" is
displayed.
To cancel, press MODE repeatedly.
Tip:
When FM stereo reception is poor, switching to monaural
reduces noise.
To switch the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Hold down TUNER/BAND and press POWER.
Tip:
When the AM tuning interval is changed, all preset stations
are cleared.
Hide quick links:
Advertisement
Table of Contents
