Radio Operations; Manual Tuning; Preset Tuning - Aiwa XR-X7 Operating Instructions Manual

RADIO OPERATIONS

cPRESET
f,g
sCLEAR
TUNING UP/DOWN
aSET
TUNER/BAND
En
POWER 6STANDBY/ON

Manual tuning

1 Press TUNER/BAND repeatedly to select a band.
The unit switches to the radio from any other function
and alternates between FM and AM.
2 Press f or g repeatedly to tune in a station.
"TUNE" is displayed when a station is tuned in.
"1" lights up for FM stereo reception.
When a station is tuned in, the display colour changes
for a few seconds.
To search for a station automatically (Auto search)
Hold down f or g.
The unit searches for a station and stops at reception.
To stop the search manually, press f or g.
•Auto search may not stop at stations with weak signals.
12
0-9,+10
MONO
TUNER
SHIFT
f,g
cPRESET

Preset tuning

Preset up to 32 of your favorite stations and tune them in
directly.
Presetting stations
1 Tune in the desired station.
2 Press a to store the station.
The preset number, beginning from "1", appears on the
display.
3 Repeat steps 1 and 2 to preset other stations.
•You cannot store more than 32 preset stations.
"FULL" is displayed.
•If power is interrupted for more than approximately 12 hours,
all settings stored in memory after purchase need to be reset.
Tuning in preset stations
1 Select the band.
2 Press c repeatedly.
With each press, the station with the succeeding preset
number is tuned in.
TUNER/
You can tune in the desired preset station directly by
BAND
pressing the numbered buttons on the remote control.
- To select preset number 10, press +10 and 0.
- To select preset number 15, press +10 and 5.
To clear a preset station
1 Tune in the station by preset tuning.
2 Press s, then press a within 4 seconds.
sCLEAR
Preset station numbers in the band which are higher than
aSET
the cleared number decrease by one.
Adjustments
To switch to monaural FM reception
Hold down SHIFT and press MONO TUNER on the remote
control so that "MONO" is displayed. To cancel, press
again to display "STEREO."
Tip:
When FM stereo reception is poor, switching to monaural
reduces noise.
To switch the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Hold down TUNER/BAND and press POWER on the main unit.
Tip:
When the AM tuning interval is changed, all preset stations
are cleared.