Timer Operations - Aiwa XR-M131 Operating Instructions Manual

TIMER OPERATIONS

POWER
6STANDBY/ON
aSET
TIMER/SLEEP
En
Sleep timer
Turns off the unit automatically after a specified time.
1 Press TIMER/SLEEP.
"SLEEP" is displayed.
2 Press a.
If a is not pressed within 4 seconds, the sleep timer
setting mode is canceled.
3 Press f or g repeatedly to set the sleep
timer duration.
With each press, the timer duration changes in 5-minute
steps between 5 to 240 minutes. If there is no button input
for 4 seconds, the current setting is entered automatically.
The unit turns off after the selected time.
To check the remaining time until the unit turns off
Press TIMER/SLEEP. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Press TIMER/SLEEP repeatedly so that "SLEEP" is displayed,
then press s within 4 seconds.
14
sCLEAR
f,g POWER
Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1 Press TIMER/SLEEP repeatedly so that "5" lights
up and "TM PLAY" is displayed.
2 Press a.
If a is not pressed within 4 seconds, the timer setting
mode is canceled.
3 Press f or g to set the hour of the timer-
on time, and press a.
4 Press f or g to set the minute of the timer-
on time, and press a.
5 Press f or g to select the source, and press
a.
•For timer play of a CD, select "CD".
•For timer play of a tape, select "TAPE".
•For timer play of a radio broadcast, select "FM" or "AM".
You will select the band later in step 8.
•For timer play of the equipment connected to the AUX
jacks, select "AUX".
a
f,g
6 Press f or g to set the timer-activated
duration, then press a.
s
With each press, the timer-activated duration changes in
5-minute steps between 5 to 240 minutes.
7 Adjust the volume and tone for timer playback.
If the volume level is set to 21 or higher, it is automatically
turned down to 20 when the unit is turned on by the timer.
8 Prepare the source.
To play CD, load a disc.
To play a tape, insert the tape.
To play the radio, select the band and tune in the desired
station.
To play external equipment connected to the AUX jacks,
set an external timer for the equipment so that its playback
begins at the same time.
9 Press POWER 6STANDBY/ON (POWER) to turn
the unit off.
"5" remains on the display to indicate the timer standby
mode.
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
•Timer playback will not begin unless the unit is turned off
first.
•Connected equipment cannot be turned on or off by the built-
in timer of this unit. Use an external timer.