Advertisement
February 2008
Line Connection and Settings
1. Loop one end of the telephone cable [A] once, then enclose it with the ferrite
core [B] as shown.
NOTE:
• Attach the ferrite core at least 9 cm (3.5 in.) from the connector.
• Attach a ferrite core to the 2nd G3 line if two G3 boards are installed.
2. Connect the telephone cable to "LINE 2" jack.
-or-
If dual G3 boards are installed connect the cables to "LINE 2" and "LINE 3"
jacks.
3. Connect the machine power cord to the power supply, then switch on the main
power switch.
4. Enter the Service Mode.
• Push [Reset], enter "107", then hold down "Clear/Reset" for at least 3 sec.
• Touch "Fax SP"
[A]
1-225
[B]
B819R113.WMF
Advertisement
