Ricoh Plockmatic SquareBack Trimmer Operator's Manual page 31

CIP Training Plockmatic SquareBack Trimmer
Troubleshooting
Jam codes list
Code # Area
507 Infeed
508 Infeed
509 Infeed
510 Infeed
511 Infeed
512 Infeed
600 Trimmer
601 Align
602 Align
603 Align
604 Clamper
605 Clamper
606 Align
607 Exit
608 Exit
609 Exit
610 Align / Clamper Q15 and Q16 (paper path sensors) covered too long.
611 Align / Clamper Q15 and Q16 (paper path sensors) covered after purge.
612 Align / Clamper Q15, Q16 and Q17 (paper path sensors) covered too long.
613 Align / Clamper Q15, Q16 and Q17 (paper path sensors) covered after purge.
614 Align / Clamper Q16 and Q17 (paper path sensors) covered too long.
615 Align / Clamper Q16 and Q17 (paper path sensors) covered after purge.
616 Stacker
701 Waste bin
Clearing a jam condition
The trim unit has two sharp knives for trimming booklets: do not touch them for
any reason and at any time. If service is needed, call a technician.
If any of the jams listed in the table above is triggered, please follow these guidelines:
•
Open the top covers and remove any booklet stuck in the paper path;
•
Check for misfed sheets and remove them;
•
Check for debris on the paper path and remove them;
•
Check that booklets on the stacker do not block path of exiting booklets;
•
Ensure there are no obstructions in the paper path;
•
Wipe all sensors (do not use any fluid to clean them);
•
Make sure the paper size is set correctly;
•
Power off and power on the machine.
Cause
Q13 and Q14 (paper path sensors) covered too long.
Q13 and Q14 (paper path sensors) covered after purge.
Q13, Q14 and Q15 (paper path sensors) covered too long.
Q13, Q14 and Q15 (paper path sensors) covered after purge.
Q14 and Q15 (paper path sensors) covered too long.
Q14 and Q15 (paper path sensors) covered after purge.
Booklet has missed Q15 or did not go past Q15, Q16 or Q17.
Q15 (paper path sensor) not reached in time.
Q15 (paper path sensor) covered too long.
Q15 (paper path sensor) covered after purge.
Q16 (paper path sensor) not reached in time.
Q16 (paper path sensor) covered too long.
Q16 (paper path sensor) covered after purge.
Q17 (paper path sensor) not reached in time.
Q17 (paper path sensor) covered too long.
Q17 (paper path sensor) covered after purge.
Stacker is full.
Waste bin is full.
WARNING: