Power Supply - Aiwa CA-DW257 Operating Instructions Manual

Power Supply

6STANDBY
OPE/BATT
The 6 STANDBY OPE/BATT indicator lights up while electric
current flows to the unit.
Using on AC House Current
Connect the AC cord as illustrated below.
supplied AC cord
CAUTION
Use only the supplied AC cord. Use with other cords may
result in the risk of fire.
Using on Batteries
Open the lid of the battery compartment on the rear and
insert eight R20 (size D) batteries, not supplied, as illustrated
below. Then close the lid.
To switch from AC power supply to battery supply,
disconnect the AC cord from the AC inlet.
When the 6 STANDBY OPE/BATT indicator becomes dim,
the tape speed slows down, volume decreases, or sound is
distorted during operation, replace the batteries.
Notes on batteries
To avoid damage from leakage or explosion, observe the
following:
• Insert the batteries with the 0 and 9 marks correctly
aligned.
• Do not mix different types of batteries or old batteries with
new ones.
• When the unit is not to be used for a long period, remove
the batteries.
• Never recharge the batteries, apply heat to them or take
them apart.
• Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
1
to the AC inlet of the unit
2
to an AC outlet
(AC 230 V, 50 Hz)
R20 (D)
Connections
IMPORTANT
• Make sure that the AC cord is disconnected and batteries
are removed before connecting speakers.
• Do not connect other than the supplied speakers.
1
Position the speakers.
To couple with the speakers, slide each speaker down
into the guide brackets on the center unit until the height
is level with the unit.
To separate the unit from the speakers, slide the
speakers up and off, while pressing the speaker release
knob.
2
Connect the speakers.
Connect the right speaker cord to the R terminals, and
the left speaker to the L terminals.
Connect the speaker cord with the white broken line to
0 and the other cord to 9.
Remote Control
Insert two R6 (size AA) batteries.
When the reach of the remote control signal is less than 5
meters (16 feet), replace the batteries.
The remote control may not operate correctly when:
- The unit is exposed to intense light, such as direct sunlight
- Objects block the remote control signal to the unit
Release knob
R6 (AA)
3
ENGLISH
En
E
F
D
I
NL
Pol
Hu
CZ