Last 10" Menu - Globus GENESY 1500 User Manual

Visualization during a program execution
While a treatment is executing, the display shows the name of the program (at the
top), the number of total phases and the phase in progress, the remaining time of
the phase in progress and the type of the wave used (EMS, TEN, MICROC...). In the
programs with intermittent stimulation the time countdown graphically represents
the work or the rest phase.
How to pause a program
Press OK to pause a program and eventually press OK again to return to the
program. The intensity indicators will be reset to zero every time the treatment is
stopped or restarted.
How to stop a program
When stopping a program before its end, hold down OK for 3 seconds to turn the
device off.
How to skip a phase
Hold down the RIGHT button for 3 seconds, If you wish to pass to the following phase
before the end of the ongoing.
To return to the previous phase, press the LEFT (back) button for 3 seconds.

"Last 10" menu

The electrostimulator stores the latest 10 executed programs, which will be available
for a rapid and easy execution.
A program is stored automatically at the end of the execution. When the memory is
full, older programs are automatically deleted.
When turning device on, select "Last 10" and then confirm with OK.
Select the program you wish to execute by pressing P+ or P-.
(If no program is stored, the message EMPTY appears).
After confirming, three entries are displayed:
a. - Start
b. - Electrode placement
c. - Delete from the list
a. It is possible to execute the selected program by placing the cursor on "Start"
and choosing between two modes (automatic or normal). To activate the
automatic function press OK, whereas to activate the normal function press the
increase intensity buttons.
The message "AUTO" appears on the display above the indicator phase when the
automatic function is activated.
23
Rev.05.15