Gs V 0 M Xl Xh Yl Yh D1 - Bematech LR200M Programming Manual

Paper sensor status (n = 1, 49):
Bit
0,1
2,3
5,6
Bits 2 and 3:
[Reference] GS a
GS v 0 m xL xH yL yH d1....dk
[Name] Print raster bit image
[Format] ASCII
Hex
Decimal
0 m 3, 48 m 51
[Range]
0 xL 255
0 xH 255 where 1 (xL + xH×256) 128
0 yL 255
0 yH 8 where 1 (yL + yH×256) 4095
0 d 255
k = (xL + xH×256) ×(yL + yH×
[Description] Selects raster bit-image mode. The value of m selects the mode, as follows:
 xL, xH, select the number of data bytes (xL+xH×256) in the horizontal direction for
 yL, yH, select the number of data bits (yL+yH×256) in the vertical direction for the
 This command is effective only when there is no data in the print buffer.
[Notes]
Off/On Hex
- -
Off 00
On (0C)
4 Off 00
- -
7 Off 00
When the paper end sensor detects a paper end, the printer goes
offline and does not execute this command. Therefore, bits 2 and 3 do
not transmit the status of paper end.
GS v 0 m xL xH yL yH d1...dk
1D 76 30 m Xl xH yL yH d1...dk
29 118 48
m Mode
0, 48 Normal
1, 49 Double-width
2, 50 Double-height
3, 51 Quadruple
the bit image.
bit image.
Decimal Status for ASB
- Undefined.
0 Paper roll end sensor: paper adequate.
(12) Paper roll end sensor: paper near end.
0 Not used. Fixed to Off.
- Undefined.
0 Not used. Fixed to Off.
m xL xH yL yH d1...dk

256) (k ≠0)
Vertical
Dot Density
203.2 dpi
203.2 dpi
101.6 dpi
101.6 dpi
44
LR200M Programming Manual V1.0
Horizontal
Dot Density
203.2 dpi
101.6 dpi
203.2 dpi
101.6 dpi