Mitsubishi Electric PUMY-P200YKM2 Technical & Service Manual page 63

Check code
4400
(U8)
Abnormal points and detection methods
If no rotational frequency is detected, or detected a value outside the
specified range during fan motor operation.
●Diagnosis of defects
Make sure to turn the power OFF before connecting/disconnecting any connectors, or replacing boards.
Check the fuse on the outdoor multi
controller circuit board.
Has the fuse melted?
Check the fan motor connector (CNF1 and
CNF2) for a disconnection or looseness.
Is there any abnormality such
as disconnection, looseness or
breakage?
1 While the breaker is OFF, disconnect the compressor
wirings (U/V/W) from the outdoor power circuit board.
2 While the breaker is OFF, disconnect the fan motor
connector CNF1 and CNF2.
3 When 5 minutes have passed since turning ON the
breaker, turn SW7-1 ON.
4 Check the voltage of the outdoor multi controller circuit board.
Test points are;
· VDC approx. 310 to 350 V DC (fan connector 1–4)
· VCC approx. 15 V DC (fan connector 5–4)
· VCC approx. 0–6.5 V DC (fan connector 6–4)
Is the voltage normal?
Note: Set SW7-1 OFF after the troubleshooting completes.
OCH675D
Fan trouble (Outdoor unit)
Diagnosis
(Melted)
(Not melted)
No
No
Yes
Causes and checkpoints
Malfunction of fan motor
Disconnection of CNF connector
Defective outdoor multi controller circuit board
Replace the outdoor multi controller circuit
Yes board.
Replace the defective fan motor.*
*For the detail, refer to "Check method of
DC fan motor (fan motor/outdoor multi
controller circuit board" in chapter 8-7.
Connect the wiring/connector properly.
Yes
Replace it in case of breakage.
Replace the outdoor multi controller circuit
No
board (Malfunction of thermistor circuit).
(A connector contact failure is suspected.)
63
Remedy
z
No abnormality