Internal Parameter Selection - SanRex SANARG 300AP Operator's Manual

4.07 Internal Parameter Selection

Internal parameters can be set by pressing and holding the encoder button.
Turn the encoder to display "End" and press the encoder to return to the standby screen.
Code No. Items
P00 Anti-Stick
Setting the maximum
P14 peak current at
REMOTE
P19 2T Slope Function
P20 4TS mode Setting
AC waveform
P24
Selection
OK to Move current
P26 detect signal output
logic inversion
Operation panel lock
P31
password setting
Setting area Default
OFF / ON OFF
OFF / ON OFF
OFF / ON OFF
OFF / ON OFF
OFF / ON OFF
OFF / ON OFF
OFF / ON OFF
53
Remarks
[ON Setting]
The welding current is reduced to 25A
if the output short-circuit state continues
for 1 second or longer in stick mode.
[OFF Setting]
The welding current set on the operation
panel is the maximum current.
[ON Setting]
Maximum current is 300A.
See Section 6.6.1
See Section 6.6.2
[OFF Setting]
Sinusoidal wave
[ON Setting]
Triangular wave
[OFF Setting]
CON1_M-N short-circuited at current
detection.
[ON Setting]
CON1_M-N is open when current is
detected.
When the encoder button and mode
selection button are pressed at the same
time, the panel is locked and parameter
changes are prohibited.
[OFF Setting]
The panel lock is released by pressing the
encoder button and mode selection button
at the same time.
[ON Setting]
When P31 is turned on, a password for
unlocking the panel can be set.
When releasing the panel lock, the panel
lock can be released by setting the
password set in P31.