SanRex SANARG 300AP Operator's Manual page 49

PARAMETER
AC-SOFT mode.
This parameter operates in TIG modes only and is used to set the time for
the weld current to ramp down, after the torch trigger switch has been
DOWN SLOPE
pressed, to CRATER CUR. This control is used to eliminate the crater that
can form at the completion of a weld.
This parameter operates in SLOPE or REPEAT (4T) TIG modes only and
CRATER CUR.
is used to set the finish current for TIG. The CRATER Current remains on
until the torch trigger switch is released after it has been depressed.
This parameter operates in TIG modes only and is used to adjust the post
gas flow time once the arc has extinguished. This control is used to
dramatically reduce oxidation of the tungsten electrode.
POST-FLOW
The SAVE/LOAD buttons are used to save and retrieve a total number of 30
programs into the 300AP memory.
SAVE the Current Weld Parameters into Memory
• Press the SAVE button
• Select a memory location by rotating the control knob, 1 to 30 is displayed
• After selecting the desired memory location (ie 1 to 30), press the right
LOAD (retrieve) a Program to Control Panel
• Press the LOAD button.
• Select a memory location by rotating the control knob, 1 to 30 is displayed
SAVE/LOAD
After selecting the desired memory location (ie 1 to 30), press the right
scroll button and the machine will give a beep to confirm the weld
parameters are loaded onto the control panel.
When welding after the welding parameters have been changed, the revious
5 sets of welding parameter settings can be loaded.
Press the LOAD button and turn the Control Knob to select the history
number ("L. -1" to "L. -5") you want to call up on the parameter display.
Example: Select -2 to recall the previous welding conditions.
Press the SET button to load the welding conditions that correspond to the
displayed history number.
STICK mode of operation.
HF TIG mode of operation. A remote control device may be used for use
during LIFT TIG operation. See section 4 for the 14-Pin Remote Control
Receptacle for complete details of the remote device.
on the meter.
scroll button and the machine will give a beep to confirm the weld
parameters from the control panel are saved.
on the meter.
DESCRIPTION
49