Electric Shock - SanRex SANARG 300AP Operator's Manual

1.05.02 Electric Shock

To prevent electric shock, be sure to observe the following precaution:
Touching any parts that are
electrically "live" or "hot" may
cause fatal electric shock or
burns.
Have a qualified electrician
connect the Welding Power
Source. Check the enclosure,
base metal and jig that they are
electrically
ordnance
regulations.
Facilities Technical Standards)
Before installing, maintaining,
or inspecting this welding
equipment,
equipment for over 5 minutes
after turning off power supply
at the distribution panel switch.
Capacitors built-in may be
electrically charged even after
the power has been switched
off.
Before
make sure that no charging
voltage should be applied to
such parts.
Do not use cables which have
insufficient
damaged, or in which any
conductor
connected in
with local
(Electrical
leave the
performing works,
capacity, are
is exposed.
Tighten
securely and insulate properly.
Do not operate with welding
equipment with its cover or
enclosure loose or removed.
Do not wear damaged, torn or
wet gloves. Always wear dry
insulated gloves.
Use a lifeline harness when
performing works at any high
elevations.
Carry out maintenance and
inspection periodically and use
it after the repair of any and all
damaged parts.
Turn off both
ON/OFF switch on equipment
and
switch when not in use.
20
cable connections
the Mains
the distribution panel