Installation Recommendations; Transportation Methods - SanRex SANARG 300AP Operator's Manual

SECTION 3 - INSTALLATION RECOMMENDATIONS

3.0 INSTALLATION RECOMMENDATIONS

3.01 Transportation Methods

The case design of the 300AP incorporates a built-in handle for carrying purposes. The case
design also allows for the units to be stacked where the feet on one unit aligns with the notches
on the top of another unit.
ELECTRIC SHOCK can kill. DO NOT TOUCH live electrical parts.
Disconnect input power conductors from de-energized supply lines before
If stacking units, DO NOT stack units more than two units high. Stacked units
must be supported in an appropriate way such that the units cannot fall and
FALLING EQUIPMENT can cause serious personal injury and equipment
• Always lift the unit utilizing the handle on top of case.
• Use handcart or similar device of adequate capacity when transporting.
• If using a fork lift vehicle, place and secure unit on a proper skid before transporting.
WARNING:
moving the welding power source.
WARNING:
cause damage.
WARNING:
damage.
33