Parameter Selection - SanRex SANARG 200AP Operator's Manual

4.6

PARAMETER SELECTION

The Table below provides information of the parameters that are available for
modification using the front panel display. The table also provides information on the ranges
available for each parameter as well as to which weld process the parameter is available.
PARAMETER
AC Frequency
Wave Balance
Weld Current (STICK) 5 to 160A
Weld Current (TIG)
Pulse Base Current
Pulse Peak Current
Hot Current
Initial Current
Crater Current
Pulse Duty
Pulse Frequency
Pre-Flow Time
Post-Flow time
Spot Time
Up-Slope Time
Down-Slope Time
*1 : The values listed in the "Default" column are the "Factory Default Settings". Once these are
changed, the last setting(s) before the unit is turned off will remain in memory for the next turn
on. These NEW settings will become the new default setting. The user must manually adjust
the setting to the values in the above chart to return to the "Factory Default Settings".
*2 : Pulse frequency units are dependent on frequency setting range as shown below:
RANGE
200AP
15 to 150Hz
10 to 65%
5 to 200A
5 to 200A
5 to 200A
0 to 70A
5 to 200A
5 to 200A
15 to 80 %
0.5 to 500.0 Hz
0.0 to 1.0 sec
0.0 to 60 sec
0.5 to 5.0 sec
0 to 15 sec
0 to 25 sec
Setting range
0.5 to 20 Hz
20 to 100Hz
100 to 500Hz
TABLE 4-3 : Front Panel Parameter Selection Ranges.
Default *1 Units
60Hz 1Hz
20% 1%
80A 1A
80A 1A
80A 1A
120A 1A
20A 1A
30A 1A
30A 1A
50% 1%
100.0Hz *2
0sec 0.1sec
10sec 0.1sec
2sec 0.1sec
1sec 1sec
3sec 1sec
Units
0.1Hz
1Hz
5Hz
47
Process
STK LFT HF
YES YES YES
YES YES YES
YES YES YES
YES YES YES
NO YES YES
NO YES YES
YES NO YES
NO YES YES
NO YES YES
NO YES YES
NO YES YES
NO YES YES
NO YES YES
NO YES
NO
NO YES YES
NO YES YES