Operator Controls, Dimensions & Outline; Dimensions And Outline; Operator Controls, Location And Functionality - SanRex SANARG 300AP Operator's Manual

SECTION 4 - OPERATOR CONTROLS, DIMENSIONS & OUTLINE
4.0 OPERATOR CONTROLS, DIMENSIONS & OUTLINE

4.01 Dimensions and Outline

The figure below shows the dimensions, in millimeters, and the outline of theSanRex model 300AP.

4.02 Operator Controls, Location and Functionality

Refer to the figure above for the corresponding reference numbers.
1. Control Knob
This knob is used to change the value of the selected weld parameter, rotate it clockwise to
increase the selected weld parameter and counter clockwise to decrease the value. The value is
indicated on the digital meter. Pushing the knob in previews the actual welding voltage while
welding.
2. 14-PIN Remote Control Receptacle
The 14-PIN Remote Control Receptacle is used to connect a remote current control devices to
the welding Power Source. To make the connection, align the keyway, insert plug, and rotate
threaded collar fully clockwise. See Section 4.3 for details description of the 14-PIN Remote
Control Receptacle.
FIGURE 4-1 : 300AP Dimensions and Controls
43