SanRex SANARG 300AP Operator's Manual page 14

SOURCE OF
SYMBOL
Hot Metal, Slag, Arc
Rays, Hot Work Piece
Optical Radiation and
Arc Heat
Cuts, Scrapes, Heat,
Flames, Molten Metal,
Wet Gloves, Insulation
Failure
Coating of Steel
Reactive Force from
Tools,
Tool Jammed or Coming
Loose
HAZARD
Thermal
Thermal
Mechanical,
Thermal,
Electrical
Fumes and
Gases
Mechanical
HAZARD HOW TO AVOID
Use approved helmets or hand
shields that provide protection
for the face, neck, and ears, and
wear a head covering.
Wear approved safety goggles or
safety glasses with side shields,
even under your helmet.
Wear dry, hole-free insulating
gloves.
Establish a written policy
documenting general safety
requirements for the wearing of
contact lenses. Conduct an eye
hazard evaluation in the
workplace
Gloves should be:
Dry and moisture resistant.
In good condition, no holes or
tears.
Flame resistant.
Electrically and thermally
insulated to suit the process.
Obtain the Material Safety Data
Sheets (MSDSs) for all materials
used. Read and understand the
specification for coating type
and coating weights. Find out
what hazardous materials are
present or might be given off by
the coating when it is exposed to
the arc of high temperatures
Wear proper head, eye and hand
protection.
Use face shields, safety glasses,
and goggles as appropriate.
Inspect tools before use.
Never use a tool that is in poor
or faulty condition.
Keep all tools in good condition.
14