Table of Contents
Advertisement
SECTION 3- INSTALLATION RECOMMENDATION
3.0
INSTALLATION RECOMMENDATIONS
3.1
TRANSPORTATION METHODS
The case design of the 200AP incorporates a built-in handle for carrying purposes.
The case design also allows for the units to be stacked where the feet on one unit aligns
with the notches on the top of another unit.
ELECTRIC SHOCK can kill. DO NOT TOUCH live electrical parts.
Disconnect input power conductors from de-energized supply lines before
moving the welding power source.
If stacking units, DO NOT stack units more than two units high. Stacked units
must be supported in an appropriate way such that the units can not fall and
cause damage.
FALLING EQUIPMENT can cause serious personal injury and equipment
damage.
• Always lift the unit utilizing the handle on top of case.
• Use handcart or similar device of adequate capacity when transporting
• If using a fork lift vehicle, place and secure unit on a proper skid before transporting.
WARNING:
WARNING:
WARNING:
29
Advertisement
Table of Contents
