Care And Maintenance - Nivel System CL2 Manual

USING YOUR LASER
Power Supply
The CL2 is powered by four AA alkaline batteries.
Setting Up

Select a place as close as practical to the work site.
Ensure the location is clear of traffic.

Place the laser on a level surface such as a bench or mount.
Operation

To turn the unit on turn the power switch to "on" position. Self
levelling will commence and all dot and line beams will appear.

If the unit is outside the self levelling range the unit will not
level causing the speaker to beep and the laser beam to turn off.
 Press the dot / line mode button on the control panel to
cycle through the active beams

CARE AND MAINTENANCE


Reflective surfaces such as glass may reflect the beam, causing
two beams to strike the detector at the same time. This may create
inaccurate reference points.

This is a precision instrument and should always be
transported within the carry case provided.

Always turn the on/off lock to "off" when transporting the unit.

Whenever possible, store the instrument in a dry, shady location.

The laser should be calibrated every 6 months, if ongoing
accurate levelling is required or an impact has occurred.

The operator should check the laser for accuracy before
precision levelling is attempted.

Clean the instrument with a dry, soft cloth after use in dusty,
damp or wet conditions before storing.

Smudges and fingerprints may be removed with a damp
tissue or a soft, lint-free cloth