Related Manuals for Nivel System NL810
Summary of Contents for Nivel System NL810
- Page 1 Rotation Laser NL810 Thank you for purchasing a Nivel System NL810 laser level. To best use the purchased instrument, Please read the instructions carefully and put in a convenient spot so that in the future you will be able to use it.
- Page 2 NOTE: The device comprises a nickel-hydrogen batteries, the batteries must be recycled and should be disposed of in accordance with the requirements (WEEE-Reg.: DE23874031)
- Page 3 (laser line - point up and down). The device can also "draw" a laser line (scan function) – thanks to it it's possible to stop the beam at a given distance. NL810 models can be controlled from the device control panel or remotely, with remote control.
- Page 4 Never repair the laser by your own. Protect your eyes from damage. Never look into the laser beam Risk of fire and electric shock. Never use a wet battery. The possibility of explosion. Never use a laser level near flammable gases and liquids. ...
-
Page 5: Control Panel
If it's necessary to replace the battery - battery compartment should be unscrewed with a screwdriver. Replacement batteries can be purchased from an authorized distributor. Use levellers NL810 with care, protect from moisture. Never put a wet instrument to the transport box (wait until dry). - Page 6 that the faster the head rotates, the energy consumption is greater 3) Select the inclination in axis (X, Y) - Use the button to select the direction of the inclination (X or Y axis). Plane can be tilted up to ± 4) laser inclination mode switch (device automatically switches to manual mode) 5) movement alarm mode (TILT) - The laser is able to secure.
-
Page 7: Principle Of Operation
The inclination of laser plane NL810 allows you to incline the laser plane in one or two directions Press 4 button which will go into a mode of enter the inclinations Press 3 to enable selection of the axis along which surface will be tilted (X or Y). - Page 8 10 cm). Working with the vertical plane NL810 can set horizontal or vertical beam. If you work with a vertical laser beam you must set the laser level as in the picture beside. Remote control Features of NL810 laser level can be controlled remotely using the remote control.
- Page 9 Checking the laser level You should regularly check the following parameters of the laser level setting a horizontal plane cone error setting a vertical plane Checking and calibration of the horizontal and vertical planes is simple and in most cases can be done by the user.
- Page 10 Checking the cone error Please do this procedure after calibration of horizontal plane. Set the laser centered between the walls distanced from each other of 30 m. Set the instrument in the X or Y direction. Mark the position of the laser beam on both walls. Turn off the instrument and move it near to the of one of the walls (1 to 2 meters).
- Page 11 Laser sensor 1. Specification Range of reception: 50 mm Accuracy operation modes: precise: ± 1mm coarse: ± 2mm display: power DC 9 V (alkaline battery) auto turning off The sensor is automatically turn off in 30min if it will not detect a laser beam, (if you want to turn the sensor on once again please press the power button.
- Page 12 To use the free warranty extension to 24 months, the instrument must be registered within 3 months from date purchase. Registration done website: http://www.tpi.com.pl/rejestracja-gwarancji Nivel System – service and support TPI Sp. z o.o., Bartycka 22, 00-760 Warsaw, Poland +48 22 651 03 06, +48 22 651 03 09, tpi@tpi.com.pl www.nivelsystem.com...