Construction; Working Mode - YOODA SMART CONTROL UNIT Manual

2. YSC unit description

2.2. Construction

2
2. YSC unit description

2.3 Working mode

YOODA SMART CONTROL unit can work in one of the three modes.
Work mode can be changed after creating first connection of control unit through app:
Settings > Network connections > Wireless network connection
Warning! Control unit in default settings does not require password for connection, which allows for unauthorised users
to set connection and control programmed devices. For safety reasons we recommend setting control units password
(see section 5.7 of this instruction). Please remember, that control unit password is independent from Wi-Fi network
password and has to be set individually - these are two different passwords.
1. Control unit generates
own Wi-Fi network
- This is the default mode, that activates
after first startup.
- Allows to control programmed devices
without the necessity to connect to other
Wi-Fi network or to router.
- Control unit generates own Wi-Fi
network named
'SmartControl-UnitsSerialNumber'
– instruction of connection can be found
in section 3.3.
- Generated Wi-Fi network is unprotected.
Encryption method, name of the network
and password can be changed in the app:
Settings > Network connections >
Wireless network connection.
- In this mode distant remote control is
possible if control unit is connected by
Ethernet cable to the internet source
(directly or by router).
power supply
radio
LAN
Wi-Fi
4
1
3
2. Control unit uses existing Wi-Fi
network
- Easiest way is to connect control unit
to working router using Ethernet cable.
- To connect app on mobile device with
control unit can be done by logging into
local Wi-Fi network - see section 3.4.
- Other way includes connecting to
control units Wi-Fi network - see
previous paragraph.
- Network generated by control unit
can be switched off.
- This work mode allows distant
remote control – see section 5.7.
LED diodes (front):
1. Power supply
- light up diode informs if the control unit is connected to power
source.
2. Radio
- diode lights up whenever radio is activated.
3. LAN
- diode lights up when control unit is connected by Ethernet
interface.
4. Wi-Fi
- diode inform on work status of Wi-Fi interface.
Panel (back):
1. Power supply input
- entry for power supply cable.
2. Reset button
- pressing RESET button will result in deleting all Wi-Fi setting of
the control unit; pressing and holding for 5 seconds will result in
restoring factory settings.
3. Gniazdo Ethernet
- allows to connect the control unit to LAN network or router by
using Ethernet cable.
4. Antena
- antenna should be bolted to the antenna connection; antenna
works in 433MHz operating frequency.
3. Control unit connects remotely
to local Wi-Fi network
- This mode allows for control unit to be
placed in the middle of the building so
that optimal radio signal range can be
achieved.
- Mode requires to set remote connection
parameters of the control unit with local
Wi-Fi network (see section 5.6.).
- Network generated by control unit can
be switched off.
- This work mode allows distant
remote control – see section 5.7.