Advertisement
Quick Links
www.sukcesgroup.pl
In order to fully explore available functions of NANO series please take a moment and read this manual before using the device. NANO control units
are compatible with all YOODA brand devices.
1. General information
Single-channel NANO control unit , white (NANO_1Cf)
Radio receiver range is a variable value and can differ from declared values depending on conditions in which device
operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters
etc.
2. Detailed description
programming button
screw clamps
antenna
Single-channel NANO control unit
NANO_1Cf
1. Control:
can control single motor
2. Memory:
up to 20 transmitters
3. Range:
200 meters outdoor,
35 meters indoor
4. Power supply:
230 V / 50 Hz
5. Output voltage:
230 V / 50 Hz
6. Output power:
300 W
7. Dimensions:
51 x 51 x 27 mm
8. Operating temperature:
frim 0°C to 50°C
9. Protection degree:
IP 20
(front)
1
Advertisement
Related Manuals for YOODA NANO Series
Summary of Contents for YOODA NANO Series
- Page 1 NANO_1Cf www.sukcesgroup.pl In order to fully explore available functions of NANO series please take a moment and read this manual before using the device. NANO control units are compatible with all YOODA brand devices. 1. General information 1. Control: can control single motor 2.
- Page 2 3. Installation Optimal mounting parameters: 1. Minimal length from the ground > 1,5 m, 2. Minimal length from the wall and ceiling > 0,3 m, 3. Minimal length between receivers > 0,2 m. power supply: motor: 230 V / 50 Hz 230 V / 50 Hz Installation of the tubular motor should be performed by specialists with 1kV or higher SEP-certified electrician's licence (SEP - Association of Polish Electrical Engineers) or equal license.
- Page 3 6. Programming another transmitter 1. The receiver can be controlled by a maximum of 20 transmitters. 2. Longer than 4 seconds pause between series of button clicks during programming will cause device to switch off from programming mode without saving any changes. Press Control unit will Press...