A 15% restocking fee will be no cost to you. If a service person is needed, Sports Attack will pay the pre-approved charged for any items accepted labor charge to get your machine back in working order.
SAFETY INSTRUCTIONS ELECTRICAL If you turn off your ELITE e-Hack Attack or if it gets unplugged, WAIT 20 SECONDS SHOCK HAZARD BEFORE POWERING UP YOUR ELITE E-HACK ATTACK. The ELITE e-Hack Attack must Failure to do so can lead to garbled/unreadable screen displays.
To set password Carefully read all instructions in fill in last name, city and state of this manual, and all labels and birth. The password must consist of warnings on ELITE e-Hack Attack 4 digits only - no letters or special before using this machine. characters. Repeat 4 digit code Use machine only under adult to verify.
Page 5
Carefully read all instructions in pitches. A Standard Pitch may this manual, and all labels and be modified, named and saved warnings on ELITE e-Hack Attack for future use as a Favorite Pitch before using this machine. or in a Favorite Sequence. Use machine only under adult Manual Pitches supervision.
Page 6
Adjusters to create a custom Carefully read all instructions in pitch. this manual, and all labels and Save to Favorites warnings on ELITE e-Hack Attack This will save the pitch to before using this machine. FAVORITE PITCHES. The pitch will then be named there.
Page 7
Press ENTER when complete. ELECTRICAL SHOCK HAZARD Save Pitch Select an unused location (EMPTY The ELITE e-Hack Attack must be PITCH) or a previously names connected to a properly location that the new pitch will grounded electrical receptacle. REPLACE. Or, select the INSERT button. Next, touch a PITCH NAME Do not operate on wet ground.
Page 8
(KPH). ELECTRICAL System Suspend SHOCK HAZARD When enabled, the motors will The ELITE e-Hack Attack must be shut down and the ELITE will return to the WELCOME screen connected to a properly after a preselected time interval grounded electrical receptacle.
Diagnostic[23] = “Bus undervoltage. The bus voltage can be monitored as seen by each of the 4 drives on the Diagnostic page. It should not be less than 68V. Check the power cord and the wall outlet and confirm correct size and gauge cord is used and restart machine. If problem persists, call Sports Attack.”; Diagnostic[24] = “Motor overload. The motor has exceeded rated load current for an extended period of time. With power off, spin each of the pitching wheels by hand and compare the ease with which they spin. Inspect the motor/wheel in...
Page 10
If no problem found call Sports Attack.”; Do not operate on wet ground. Diagnostic[39] = “Ball pitch limit switch is jammed. Check to make sure that balls aren’t CAUTION jammed in the pitching machine.
3. Remove (unsocket) both front legs and store by inserting in the travel storage sockets. 4. See Figure 8 at right: Again, using the rear leg as a handle, tip ELITE e-Hack Attack back until machine can be comfortably rolled on the travel wheels. ELITE e-Hack Attack can now be rolled and maneuvered off of the field. 5. To prevent damage in transport, rest the throwing head on the wheel guard and yoke; motors should be down, and the control panel pointing up.
Page 12
(wheel) use only and for those wanting that more realistic look and feel of a baseball. Sports Attack has a full line of pitching machine balls to cover every need for indoor or outdoor use.
Need help?
Do you have a question about the ELITE E-HACK ATTACK and is the answer not in the manual?
Questions and answers