Table of Contents
Advertisement
CLEANING & CARE
Warning: Be sure that the unit is disconnected from the power outlet when performing user
maintenance. Do not immerse the unit in water.
Drain the remaining water in the tank and clean it after every use. Please use detergent to
clean the accessories (jet nozzle and round brush) when they are dirty, then wash them with
clean water and dry them in air.
How to decalcify the water tank interior
To clean calcium deposits that build up inside the water tank, add one or two tablespoons of
white vinegar to a full water tank, close the water tank cap and shake the contents. Do not
turn the steamer on. Let it sit for a few hours. Then, empty the water tank and refill with
clean water and empty until it rinses clear.
Cleaning procedure to remove lime scale
If your unit begins to produce steam more slowly than usual or stops producing steam you
may need to remove lime scale. Lime scale can develop over time on the metal parts and
greatly affect mop performance. It recommends removing lime scale on a regular basis, at
least once a month, especially in areas with hard water. The frequency of lime scale removal
depends on the hardness of your tap water and how often you use the steam mop.
To remove lime scale from the unit please follow these procedures:
1.
Prepare a solution of 1/3 white vinegar and 2/3 tap water and add to the water
tank.
2.
Secure the position of the unit to ensure steam released is aimed away from the
floor or surrounding objects and surfaces. Plug the unit in and turn ON by pressing
the power switch. Allow the unit to produce steam until the vinegar/ water solution
is used up.
3.
Repeat the above procedure as many times as necessary until a normal steam
flow rate is achieved.
4.
Fill the water tank with fresh water and rinse out.
5.
Fill the water tank with fresh water, attach to the unit and release steam through
the system until the water tank is empty.
Advertisement
Table of Contents
