Fingerprint Reader Board - HP ProBook 635 Aero G8 Maintenance And Service Manual

4. Lift the back of the board up, and then remove board from computer (4).
Reverse this procedure to install the USB board.

Fingerprint reader board

To remove the fingerprint reader board, use this procedure and illustration.
Table 6-8 Fingerprint reader board description and part number
Description
Fingerprint reader board
Fingerprint reader board cable (included in Cable Kit)
Fingerprint reader board bracket
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the fingerprint reader board:
1. Remove the Phillips M2.0 × 2.0 screw (1) that secures the fingerprint reader bracket to the computer, and
then remove the bracket (2).
2. Disconnect the cable from the ZIF connector on the fingerprint reader board (3).
52 Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 43).
35).
Spare part number
M30665-001
M30646-001
M36397-001
43).