HP ProBook 635 Aero G8 Maintenance And Service Manual page 71

7. If you need to remove the display panel:
NOTE: You do not need to remove the hinge cover or hinges to remove the display panel.
a. Multiple alignment tools are included with the replacement panel. Check the fit of the various
alignment tools on the display assembly. Make note of the best fitting alignment tool to use when
replacing the display panel.
b. The display panel is secured to the display enclosure with tape that is installed under the left and right
sides of the panel. To remove the panel, use tweezers to grasp the end of the tape (1). While turning
the tweezers, wrap the tape around the tweezers (2) as you continue to pull the tape out from behind
the display panel (3). You must pull the tape multiple times before it is completely removed.
c. Rotate the display panel over and place it next to the display enclosure (4).
The display panel is available using the following spare part numbers:
M52479-001: For use on computer models with display panels with privacy filter
M52748-001: For use on computer models with display panels with 400 nit brightness
M52747-001: For use on computer models with display panels with 250 nit brightness
The LCD Support Kit is available using spare part number M33161-001 and includes double-sided
tape and foam sponge.
d. Place the display panel next to the display enclosure (1).
e. Lift the tape from the connector on the display panel (2), rotate the locking lever (3), and then
disconnect the cable from the panel (4).
Display assembly 63