Advertisement
Connect to Fiber Under Test (FUT):
All fibers and connectors should be inspected prior to connection, as described on page 1. The OTDR
may be connected to the FUT via an optical patch panel (OPP) bulkhead or an optical coupler as
follows:
1. Inspect the OTDR port on top of the test set.
2. If the interface to the FUT is a patch cord, connect the patch cord to an optical coupler with the
same connector type.
3. Inspect the FUT connected to the coupler or OPP.
4. Inspect the fiber end face of the Launch Cable.
5. Connect the Launch Cable to the OTDR port.
6. Inspect the other fiber end face of the Launch Cable.
7. Connect the Launch Cable to the coupler or OPP.
Launch and Configure Test:
1.
Press the ON/OFF button to turn on the test set.
2.
If files are to be saved, tap the FILE Button and tap the results folder. Otherwise,
proceed to step 4.
3.
Tap the Create Directory soft key, enter a name for your new folder, and tap the Enter
key. All trace files will be saved to this directory.
Figure 3: Connecting OTDR to FUT via Coupler or OPP
Figure 4: File Explorer
VIAVI Solutions
Advertisement
