Use and maintenance
Operating guidelines AS4335C
Remove the red cover, fill the tank with
clean water and use maximum temperature
40 degree. Add appropriate low foaming
detergent according to dosage information.
Press solution and vacuum buttons on and
start cleaning by placing the hands on the
safety switches.
Press one of the safety-switch levers on the
handle to engage the brush/pad-holder,
then release it.
When scrubbing is complete, turn off
the machine to perform the following
maintenance.
July 2020
Check the level of water with the red ball
on the left side of the machine.
Lift the deck by pressing the pedal.
Lift the squeegee up by hand until it locks in
up position and turn suction off for double
scrubbing.
To go back to working mode, use the red
lever to release the squeegee and turn
suction on again.
Connect the power supply plug to the
electrical mains and press machine ON
button.
Place the brush or the pad-holder under the
deck and Lower the deck or the brush/ pad
holder by pressing the pedal. The squeegee
is raised and lowered with the deck.
Solution flow can be adjusted according to
the scrubbing need