wolke m600 Universal Operator's Manual page 41

Wolke m600 Universal Operator Manual
Printhead Setting
Navigate to Tools > Setup > Printhead (see Figure 4-4).
Figure 4-4: Printhead Setting
Buttons
Enabled
Registration Delay
Product Direction
Horizontal Print
Density
Maximum Supported
Print Speed
Vertical Print Density
Print Orientation
Print Speed
Table 4-3: Printhead Setting
4-6 Using the Tools Page
Description
Allows the user to enable or disable the
printhead for printing.
Allows the user to set the print
registration in millimeter (mm).
Configures the direction of product travel
as viewed from behind the printhead
Allows the user to set the print
resolution. For more information, refer
"How to Adjust Print Resolution" on
page 5-17.
Shows the maximum value of the print
speed that can be set in millimeter per
second (mm/s).
Allows the user to set the print
resolution.
Allows the user to set the print
orientation to 0 or 180 degrees
depending on requirements.
Allows the user to set the print speed in
millimeter per second (mm/s) if
configured for 'Fixed speed printing'.
Rev AB