wolke m600 Universal Operator's Manual page 125

Wolke m600 Universal Operator Manual
Error No
E1208
E1209
E1210
E1211
E1212
Table 8-1: CLARiTY Error Messages (Continued)
8-8 CLARiTY Error messages
Report on CLARiTY Operator Interface
'Invalid Job File (EAN field value out of range)' - Data
out of range, example '13' for a month code or '25' for an
hour code - correct in CLARiSOFT
barcode field in the Job file contains data that is out of
range (for example, an hour field set to 25 or a month
field set to 13). Use CLARiSOFT
the EAN128 barcode fields in the Job file. Then,
download the corrected file. Touch the "Clear" button
below, to clear this fault message.
'Invalid Job File (EAN requires decimal point specifier)' -
EAN requires digit to specify the position of the decimal
point - correct in CLARiSOFT
field in the Job file contains an application identifier that
requires a digit to specify the position of the decimal
point, but this digit is not present. Use CLARiSOFT
check and correct the EAN128 barcode fields in the Job
file. Then, download the corrected file. Touch the "Clear"
button below, to clear this fault message.
'Invalid Job File (EAN field invalid or missing check
digit)' - Application identifier requires the missing check
digit - correct in CLARiSOFT
field in the Job file contains an application identifier that
requires a check digit, but this check digit was either
missing or invalid. Use CLARiSOFT
correct the EAN128 barcode fields in the Job file. Then,
download the corrected file. Touch the "Clear" button
below, to clear this fault message.
'Invalid Job File (EAN over 165 mm long)' - Barcode too
large - resize to maximum length of 165 mm - correct in
®
CLARiSOFT . An EAN128 barcode could not be
rendered at a size of 165 mm or more which is the
maximum length for this type of barcode. Use
®
CLARiSOFT to check and correct the EAN128
barcode fields in the Job file. Then, download the
corrected file. Touch the "Clear" button below, to clear
this fault message.
'Invalid Job File (Barcode Length Incorrect)' - Barcode
field does not have expected number of characters -
®
correct in CLARiSOFT . A barcode field in the Job file
does not have the expected number of characters. Use
®
CLARiSOFT to check and correct the barcode fields in
the Job file. Then, download the corrected file. Touch
the "Clear" button below, to clear this fault message.
®
. An EAN128
®
to check and correct
®
. An EAN128 barcode
®
®
. An EAN128 barcode
®
to check and
Status
Fault
Fault
to
Fault
Fault
Fault
Rev AB