wolke m600 Universal Operator's Manual page 136

Error No
E5321
E5322
E5323
E5324
E5325
E5326
E5327
Table 8-1: CLARiTY Error Messages (Continued)
Rev AB
Report on CLARiTY Operator Interface
'Group %1 - Underspeed during print' - The printer has
measured a speed from the encoder that is below the
minimum it is capable of printing at.
The print on group %1 was aborted mid-print. This
image may be incomplete.
'Printhead %1 - DPI Mismatch' - The printer attempted
to print an image that has a different DPI to the current
printer setting.
The print on printhead %1 was aborted.
'Group %1 - DPI Mismatch' - The printer attempted to
print an image that has a different DPI to the current
printer setting.
The print on group %1 was aborted.
'Temperature Readings Missed' - The number of missed
temperature readings on Printhead %1 has exceeded
the defined limit.
This may cause overheating and damage to the
printhead.
Please check that prints are far enough apart that the
temperature can be read.
Touch the "Clear" button below to dismiss this error.
'Cap Fault' - The capping device on Printhead %1 is in a
fault condition.
This will cause printing issues.
To clear this error, shutdown the printheads and then
power them up again.
If the problem persists, call your maintenance engineer
or local service representative.
'Cartridge Fault' - The printhead cartridge in Printhead
%1 is in a fault condition.
This will cause printing issues.
Please clean the cartridge connection pins or replace
cartridge.
To clear this error, shutdown the printheads and then
power them up again.
If the problem persists, call your maintenance engineer
or local service representative.
'Cartridge Fault' - The printhead cartridge in Printhead
%1 is in a fault condition.
This will cause printing issues.
Please clean the cartridge connection pins or replace
cartridge.
To clear this error, shutdown the printheads and then
power them up again.
If the problem persists, call your maintenance engineer
or local service representative.
Wolke m600 Universal Operator Manual
Status
Fault
Fault
Fault
Fault
Fault
Fault
Fault
CLARiTY Error messages 8-19