Uninstalling And Installing The Silicone Belt - Prince Castle CTS-W Operation Manual

Contact Toaster – Single-Sided
CTS-W/CTS-M/CTS-WS/CTS-WCE/CTS-MCE/CTS-WSCE
IMPORANT: Belt is consumable that must be replaced every 2-6 months, dependent on usage and wear.
Uninstall the silicon belt. Ensure the CTS is off and
1
not hot to the touch.
A. Remove the conveyor. Use handle on back to lift
the conveyor up and away from CTS. Lay it on a
clean surface with the flat side (back) down.
B. Rotate the conveyor until the area where the two
ends of the belt meet is near the top. Fold the flap
back to access the two ends.
C. Unhook the two clips on the end of the belt without
the flap from the wire conveyor and rotate the
conveyor towards the top until the unattached end
of the belt is hanging free.
Printed in USA 03/17 © 2017

Uninstalling and Installing the Silicone Belt

Top
D. While holding the free end with one hand, rotate
the conveyor back toward the bottom so you can
access the attached end, lift the flap and unhook
the two clips on that end to free the belt.
Install the silicon belt.
2
A. Locate the end of the belt that has the flap.
B. With the flap positioned toward the top of the
conveyor, fold back the flap and hook the two clips
onto any wire on the conveyor.
C. While holding the silicon belt with one hand, slowly
rotate the conveyor toward the top until the
attached end is near the top again.
D. Folding the flap on the attached end back, hook the
two clips on the free end of the belt onto the wire
conveyor so the two ends meet. Release the flap.
Reinstall the conveyor. Using the handle on back to
10
lift the conveyor, line up the side posts of the conveyor
with their notches on the CTS. Move the conveyor into
the CTS and gently release.
10
TM
299-500revC-EN