LG ARND DCR4 Series Installation Manual page 7

OPERATION
DANGER
or submerged.
Use a dedicated power source for this product.
WARNING
Do not allow water, dirt, or animals to enter the unit.
Do not touch refrigerant piping during or after operation.
It can cause burns or frostbite.
Do not operate the unit with the panel(s) or protective
moving parts.
The rotating, hot, cold, and high-voltage parts of the unit can cause
physical injury or death.
CAUTION
To avoid physical injury, use caution when cleaning or servicing the unit.
that no metal scraps, screws, or bits of wiring have been left
inside or surrounding the unit.
Do not use this equipment in mission critical or special-
purpose applications such as preserving foods, works of art,
wine coolers or refrigeration.
Provide power to the compressor crankcase heaters to ap-
plication outdoor units at least six (6) hours before operation
begins.
Starting operation with a cold compressor sump(s) may result in severe
bearing damage to the compressor(s). Keep the power switch on during
the operational season.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
SAFETY PRECAUTIONS
Do not operate the disconnect switch with wet hands.
If refrigerant gas leaks out, ventilate the area before operat-
ing the unit.
If the unit is mounted in an enclosed, low-lying, or poorly ventilated area
shock, explosion, physical injury or death.
Periodically check power cable and connection for damage.
Cable must be replaced by the manufacturer, its service agent, or similar
Securely attach the electrical cover to the unit.
Non-secured electrical covers can result in burns or electric shock due to
dust or water in the service panel.
Ensure no power is connected to the unit other than as
directed in this manual. Remove power from the unit before
removing or servicing the unit.
Do not block the inlet or outlet.
Unit may malfunction.
Securely attach the electrical cover to the unit.
panel.
Periodically verify the equipment mounting hardware has not
deteriorated.
If the base collapses, the unit could fall and cause property damage or
product failure.
Do not allow water, dirt, or animals to enter the unit.
There is risk of unit failure.
7