LG ARND DCR4 Series Installation Manual page 47

Navigation
The function buttons for the keypad / display and the virtual keypad / display and Web UI configuration described in table below.
Figure 33: Virtual Keypad.
Table 24: Function Buttons for the Keypad / Display and the Virtual Keypad / Display.
Button Description
Main Menu (target button)
Alarm
Escape
Up
Enter
Down
Navigates directly to the Main Menu from any screen. Backlight indicates that the unit is en-
abled. From the Main Menu, navigate to the following screens (see also the Menu map section):
• Unit Enable
• Unit Status
• Control Variables
• Alarm Menu
The Alarm button flashes when there is an active alarm. Press to view active alarms. Press twice
to go to the alarms reset screen.
Access from the Main Menu to view the Unit Status screen. Press to navigate one menu level
back. Press when editing a variable to cancel editing.
Navigates through the menus / screens. Press after entering a variable to increase a current
value.
Press to enter a highlighted menu or screen item. Press to enter a writable variable, and press
again to confirm the new variable value.
Press to navigate menus / screens. Press after entering a variable to decrease the current value.
These two buttons on the virtual keypad / display simulates two-button actions on the handheld
keypad / display.
To simulate pressing two buttons simultaneously:
1. Click on 2-Button Click.
2. Sequentially click two keypad buttons (Main, Alarm, Escape, Up, Enter, Down).
To simulate pressing and holding two buttons simultaneously:
1. Click on 2-Button Hold.
2. Sequentially click two keypad buttons (Main, Alarm, Escape, Up, Enter, Down).
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
PRE-COMMISSIONING
Figure 34:
Login with Service Manager > SVC > Configuration.
Functions
DOAS Controller Setup
47