Device Configuration - Auerswald TFS-Dialog 400 Advanced Information

6. Additional settings can be configured by entering
window.
Note: If you make an incorrect entry, instead of the confirmation
tone you will hear a busy signal for 1–2 seconds. Then begin again by
dialling *.
Note: After you hear a confirmation tone, configuration mode
remains active for another 4 minutes. You automatically leave configu-
ration mode if you do not perform any configuration actions during this
time, or if you press the door bell buttons.

Device configuration

Only the volume and brightness device properties can be set directly in the
device without using an internal telephone or the app.
Requirements:
•
The default PIN (0000) has been changed
1. Press the buttons on the device as shown in the figure.
TFS-Dialog 400 - Advanced Information V02 11/2020
Configuration
Device configuration
*
within the 4-minute
30