MSB Technology The Reference DAC User Manual page 13

Setup Menu Continued...
Volume
(Startup volume
and DSD
settings)
Renderer
Power
Renderer
Remote
Analog*
(Analog input)
*Preamp output
only
Output**
(Output Level)
**Base output
only
SN: This screen displays the serial number of the DAC.
Code This screen displays the current revision # of firmware
IN1 to IN4 Lists the installed input module in slot A, B, C, and D
Output Module Displays the current output module installed and the
This can be adjusted from 0 - 100. This is the default
volume the DAC will power up at. If you choose to use the
DAC with a external preamp, we recommend setting the
default volume to 98. (Default is 70)
Off Optimized
• Optimized mode. The optimized mode is the DSD
decimation done using a special method developed by
MSB.
Off Native
• Native mode. The Native DSD signal is sent unprocessed
direct to the Hybrid DAC modules.
Auto (default)
• Renderer is powered off if no connection is found
Off
• Renderer always off
On
• Renderer always on
Enable
• The transport buttons on the remote work to control
renderer functionality
Disable
• The transport buttons on the remote only work for the
transport
Off (Default)
• Disables the analog input. Leave the analog input
disabled unless you have it connected. This will prevent
the DAC from switching to a floating input.
On
• Enables the analog input and uses the volume control.
Bypass
• Enables the analog input and bypasses the volume
control.
Low
• -6dB output level with a 75 ohm output impedance. This
setting is recommended if you decide to use a external
preamp.
High (Default)
• Standard output level with a 150 ohm output impedance
installed in the DAC.
output impedance.