Setup And Quick Start - MSB Technology The Reference DAC User Manual

Setup and Quick Start

The interface is quite simple with few user controls. Input source
defaults on to auto switching. The display will let you know if you
have an active input. On power up, the volume is reset to the
programmed startup level. Shipping default is 70. Turn the volume
knob up until you hear music.
Power The DAC comes with a high performance powerbase. The
powerbase automatically detects and switches between
240V and 120V.
works at any voltage, but a linear supply with automatic
switching of the transformer leads. The power supply is
switched on and off with a button on the front or via the IR
remote. Plug in the provided AC cable to the back of the
powerbase, then plug in the provided DC interconnects
from each of the two plugs on each side of the powerbase
to each of the two plugs on each side of the DAC. To
unplug the DC power cables, just pull on the barrel of the
connector housing.
Inputs The DAC comes with the digital input modules of your
choice. Connect any digital input to any active digital audio
source. The frequency and bit depth of the incoming
signal will be displayed on the front panel.
Outputs Connect the balanced analog outputs to any amplifier.
The output level is controlled with the knob or remote.
When stacking the units, you will find enclosed black plastic square
inserts. These inserts fit into the square holes in the top of each
chassis. This will allow you to stack the units without scratching the
chassis.
Burn-In
The feedback we receive leads us to recommend at least 100 hours of
burn-in on this DAC. Customers generally report improvement up to
one month.
This is not a switching supply that