Related Manuals for MSB Technology ADD-1
Summary of Contents for MSB Technology ADD-1
- Page 1 MSB TECHNOLOGY ADD - 1 Analog to Digital Converter Audio Director Owners Manual MSB TECHNOLOGY CORPORATION 14251 Pescadero Road La Honda, CA 94020 Email: info@msbtech.com TECHNOLOGY (650) 747-0400 Fax: (650) 747-0405...
-
Page 2: Table Of Contents
Why use an A/D converter? ....Copy Protection ........Operation..........Autoswitching explained Line Level Inputs Phono Inputs Manual control (External Interface) The Front Of The ADD-1....... The Back Of The ADD-1....... Specifications........Troubleshooting ........Service and Warranty......Other MSB Products ...... -
Page 3: Foreword
OREWORD ROUBLESHOOTING Symptom Solution The MSB Audio Director and Digitizer (ADD) is optimized in every way No LEDs Light Check power supply connection for the very highest quality digital to analog conversion, and comprises the Check voltage of power supply (120V-240V) latest 96k/24-bit A/D technology. -
Page 4: Why Use An A/D Converter
A/D C HY USE AN ONVERTER PECIFICATIONS The greatest benefit derived from using a high quality A/D Converter is improvement of sound quality when used in conjunction with a digital audio Resolution 24 bit system. Two primary groups of digital applications benefit: the digital re- corders and Digital Signal Processing Systems (DSPs). -
Page 5: Operation
LINK and a very high quality digital stream is created, with no copy ADD-1 EHIND THE protection. Although the quality is not as good as the original, it is far better that if the analog outputs of the source were connected to the analog inputs of the recorder. - Page 6 ADD-1 RONT OF THE controls (with no gain). The higher level of these sources should be attenu- ated, ideally with a passive volume control (a high quality resistor to ground). Measurements are normally made with a test disc and oscilloscope, but if the output level and impedance is known, the amount of attenuation can be calculated.
Need help?
Do you have a question about the ADD-1 and is the answer not in the manual?
Questions and answers