Axis P5655-E User Manual page 24

AXIS P5655-E PTZ Network Camera
Specifications
When connecting external equipment, a separately sold Axis Multicable C I/O Audio Power 1 m/ 5 m or a separately sold Axis 10-pin
Push-pull System Connector is required in order to maintain the product's IP rating. For more information, see Multicable connectors
on page 24 and Axis 10-pin push-pull system connector (sold separately) on page 25.
Multicable connectors
1 Camera multiconnector
2
I/O terminal block
3
Audio terminal block
4
Power connector
The multicable provides the following connectors:
Power connector - 2-pin terminal block used for power input. The polarity of the cables does not matter. Use a Safety Extra
Low Voltage (SELV) compliant limited power source (LPS) with either a rated output power limited to ≤100 W or a rated output
current limited to ≤5 A.
Audio connector - 4–pin terminal block used for audio in and audio line out. This can be connected to a public address (PA) system
or an active speaker with a built-in amplifier.
Function
Audio In
Audio Line Out
GND
I/O terminal connector - Use with external devices in combination with, for example, tampering alarms, motion detection, event
triggering, and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the
interface to:
Multicable overview
Pin Notes
1
Balanced or unbalanced input for a mono microphone or line signal
3
Can be connected to a public address (PA) system or an active speaker with a built-in
amplifier
2, 4 Ground
24