Axis P5655-E User Manual page 10

AXIS P5655-E PTZ Network Camera
Additional settings
4. From the list of actions, select Go to preset position.
5. Select the preset position you want the camera to go to.
6. Click Save.
Direct the camera and open the lock to a gate when someone is nearby
This example explains how to direct the camera and open a gate when someone wants to enter during daytime. This is done by
connecting a PIR detector to the product's input port and a switch relay to the product's output port via the multicable.
Required hardware
• Multicable (sold separately), see Multiconnector on page 23.
• Mounted PIR detector
• Switch relay connected to the gate lock, in this case the switch is normally closed (NC)
• Connecting wires
Physical connection
1. Remove the plug from the camera's multi-connector and connect the multicable.
2. Connect the wires from the PIR detector to the input pin, see Multiconnector on page 23.
3. Connect the wires from the switch to the output pin, see Multiconnector on page 23.
Configure I/O ports
You need to connect the switch relay to the camera from the camera's webpage. First, configure the I/O ports:
Set the PIR detector to an input port
1. Go to System > I/O ports.
2. Select Input in the Port 1 drop-down list.
3. Give the input module a descriptive name, for example "PIR detector".
4. To trigger an event whenever the PIR detector senses motion, select Open circuit in the drop-down
list.
Set the switch relay to an output port
1. Go to System > I/O ports.
10