Table of Contents
Advertisement
Setup
You have two options to set up the
MUSICSTATION:
1. With the wall bracket
attached, it stands
upright and projects
sound directly to the
front.
2. If you remove the
wall bracket (see
"Wall mounting"),
you can tilt the
MUSICSTATION
back slightly so that
it projects sound at
an upwards-facing angle.
Wall mounting
Proceed with care when mounting the
MUSICSTATION on the wall and follow
the instructions below.
You will need the following material to
mount the device on a solid, smooth
stone wall (not included in the
package contents):
• 3 dowels (ø 6 mm)
• 3 screws, 5 × 40 mm, screw head
ø 8–9.5 mm
CAUTION
Risk of injury/damage!
– Only qualified persons may
mount the MUSICSTATION on
the wall.
– The device may only be
mounted on a suitable,
solid wall. Special dowels or
anchors may be necessary
when mounting the product
on lightweight walls. Consult
a qualified professional in
this case.
– Make sure that there are no
cables or pipes in the drilling
areas. Before you drill, use a
metal detector to check the
applicable areas. Otherwise,
there is a risk of electric
shock/short circuit!
Important: To be able to push the
MUSICSTATION onto the wall bracket,
there must be a free space of 12 cm
above the wall bracket!
1. Remove the wall bracket: To do so,
push the two small levers to the
back (away from the device) and
pull the wall bracket down and off.
• MUSICSTATION
17
Advertisement
Table of Contents
