Protective Film - Teufel MUSICSTATION Technical Description And User Manual

2. Place the wall bracket in the
desired position and use the three
holes to mark the drill holes on the
wall. Use a ruler, pencil and spirit
level for this.
3. Use a metal detector to check the
drill areas. If necessary, select
another area for mounting.
4. Use a 6 mm rock drill to drill a hole,
which is approx. 45 mm deep, at
each marked position.
5. Insert a dowel (ø 6 mm) all the way
in each drill hole.
6. Screw the wall bracket on the wall
using three screws.
7. Connect the mains and antenna
cords to the corresponding jacks
on the back of the MUSICSTATION
(see "Connection" on the next
page).
8. Put the MUSICSTATION
on the wall bracket
and pull it down until
the two levers audibly
lock into place.
18 • MUSICSTATION

Protective film

Upon delivery, the display panel is
protected with a film, which also acts
as a quick guide.
You can pull the protective film off:
1. Switch the MUSICSTATION off, if
applicable.
2. Take hold of the film by the red tab
on the bottom left and slowly pull
the film off diagonally upwards.