RH Teen VALENTINA UPHOLSTERED PLATFORM BED FULL & QUEEN Assembly Instructions

VALENTINA UPHOLSTERED PLATFORM BED FULL & QUEEN - ASSEMBLY INSTRUCTIONS
A. HEADBOARD (1)
B. SIDE RAILS (2)
C. FOOTBOARD (1)
D. SLATS (4)
E. PLATFORMS (2)
F. CENTER FEET (WITH
ADJUSTABLE GLIDE) (4)
Phillips-Head Screwdriver (not included)
Stand the Headboard (A) upright and insert Thread Rods (1) into the prefabricated holes. Align the Side Rails (B).
Attach Curved Washer (2), Lock Washer (3), and Nuts (4) onto the Thread Rods (1) and tighten the Nuts (4)
and Thread Rods (1) with Spanner Wrech (5), as shown in Diagram I. Repeat the procedure to attach Side Rails
(B) to Footboard (C).
Attach the Center Feet (F) to the Slats (D), as shown in Diagram II.
Place the Slats (D) on the top of the Side Rail's (B) side slats and fasten using Screw (7), as shown in
Diagram Iii.
Lay the Platform Panel (E) on the top of the Slats (D), then fasten with Screw (6), as shown in Diagram IV.
1 of 2