About Android Debug Bridge (ADB) control
Elo handheld computer device supports debugging via Wi-Fi/Ethernet or using the USB cable, Type C to Type A cable.
Set I-series 4.0 to (Developer)
•
Enter Android
Settings → About Phone → Build Number.
•
Tap Build Number 7 times to enter developer mode.
•
Go back to the
•
From Developer options on- screen display, enable the option called "USB debugging".
To connect via Wi-Fi
Ensure that your computer is online and not behind a firewall.
•
Find the IP address (by going to
•
On your host computer, use the command ADB connect <IP address> to be able to perform ADB actions.
To connect via USB, perform the following steps
•
Ensure the USB cable is not connected to the i-series 4.0.
•
From the settings, enter Developers Options
•
Turn on the "Enable USB Debugging" option
•
Plug USB cable (type C) side into the computer device and (type A) to host PC.
•
In the host PC, input "ADB devices" to check if the Elo Handheld Computer serial number shows
up. If it is there, then you have connected successfully.
User Manual –i-series 4.0
Settings à System à Advanced and you will see "Developer Options".
Settings → Network & Internet → Wi-Fi →Tap the active connection → Advanced→ IP Address.
UM600410 Rev 02 page 64 of 75