Service Interval; Riding Modes - Triumph Bonneville Bobber Owner's Handbook Manual

General Information
• When the correct hour display is
shown, press and hold the SCROLL
button for one second. The hours
display is set and the minutes
display will begin to flash. The
minutes display is adjusted in the
same way as for the hour display.
• Once both hours and minutes are
correctly set, press the SCROLL
button for one second and the
display will cease to flash.

Service Interval

1. Remaining distance
2. Service symbol
When the ignition is switched on and
the distance to the next service is
61 miles (100 km) or less, the display will
flash the service symbol for five seconds
after ignition is switched on.
When the remaining distance is 0 miles
(0 km) or overdue, the service symbol
will remain on until the service has
been carried out and the system has
been reset by your authorised Triumph
dealer.
34
1 2

Riding Modes

The riding mode
adjustment of the throttle response.
Riding modes
the MODE button on the right hand
handlebar switch housing.
1. MODE button
Press and release the MODE button to
select one of the following riding modes.
Bonneville Bobber and Bonneville Speedmaster
Riding Mode Description
Standard throttle response.
ROAD
Optimal traction control setting for
road use.
Reduced throttle response when
compared to the ROAD setting, for
wet or slippery conditions.
RAIN
Optimal traction control setting
for road use in rain conditions and
allows minimal rear wheel slip.
Riding modes can be selected when the
motorcycle is stationary or moving.
system allows
are selected using
1