Tool Kit - Triumph Bonneville Bobber Owner's Handbook Manual

To refit the seat:
• Align the holes on the rear of the
seat base to the seat two locating
lugs on the mudguard.
• Slide the seat forward until the lugs
are engaged into the seat.
• Fit the fixing for the front of the
seat and tighten to 9 Nm.
• Fit the rider's seat (see page 53 ).
Warning
To prevent detachment of the seat
during riding, after fitting always
grasp the seat and pull firmly upwards.
If the seat is not correctly secured in
the lock, it will detach from the lock.
A loose or detached seat may cause
loss of motorcycle control and an
accident.
General Information

Tool Kit

The tool kit consists of an adjustment
tool and inspection cap tool.
The adjustment tool is attached to the
inside of the left hand side panel. The
adjustment tool can be used for many
tasks.
The inspection cap tool is attached to
the fuse box which is located under
the left hand side panel. The inspection
cap tool is used to open the cap on the
sprocket cover to view the brake fluid
level reservoir.
Bonneville Speedmaster Only
There is a C-spanner and an extension
handle attached to the underside of the
rider's seat. This is used for adjusting
the spring preload rear suspension
settings.
55