Faq - Leica Q2 MONOCHROM Instruction Manual

FAQ

EN
Problem
Battery issues
Battery is depleted too quickly
Charging process not starting
Charging takes too long
Charging pilot light is on, but battery isn't charging The battery contacts are dirty
Camera problems
The camera suddenly switches itself off
The camera won't switch on
Camera is heating up
The camera switches off again immediately after it
is switched on
Camera does not recognize the memory card
144
possible cause to be verified
Battery too cold
Battery too hot
LCD panel or EVF set too bright
Power save mode deactivated
AF mode permanently activated
Permanent WLAN connection
Continuous use of LCD panel (e.g. in Live View mode)
Battery has been recharged too many times
Preview of the recorded images (
Preview Preview
Incorrect battery polarization or faulty charger
connection
Battery too hot or too cold
Battery has been recharged too many times
Battery is depleted
Battery is depleted
Battery too cold
Heat development due to high-res video recording (4K) or
serial exposures with DNG
Battery is depleted
The memory card is not compatible or defective
Memory card is incorrectly formatted
Troubleshooting suggestions
Warm the battery (e.g. in pants pocket) and only insert
directly before use
Allow battery to cool down
Reduce brightness
Activate
Auto Power Off Auto Power Off
Select other mode
Deactivate WLAN when not in use
Deactivate the function
The battery has reached the end of its operating time
Replace battery
) activated Deactivate the function
Check polarization and connection
Charge the battery at room temperature
Clean the contacts with a soft, dry cloth
The battery has reached the end of its operating time
Replace battery
Charge or replace the battery
Charge or replace the battery
Warm the battery (e.g. in pants pocket)
Not a fault; allow camera to cool down if it gets too hot
Charge or replace the battery
Replace the memory card
Format the memory card in the camera