Faq - Leica M10-D Instruction Manual

FAQ

EN
Camera
Messages:
Battery capacity too low for sensor cleaning
Please stop sensor cleaning immediately
The camera won't switch on.
The date and time display is incorrect or not
shown.
Rechargeable battery/charger
The camera switches off again immediately
after it is switched on.
Pictures
The camera won't take a picture.
The picture won't save.
70
– Does the battery have sufficient charge?
Use a charged battery.
– The battery is flat.
Replace the battery.
– Is the battery inserted correctly?
– Does the battery have sufficient charge?
Use a charged battery.
– Is the bottom cover inserted correctly?
– Is there visible condensation?
This may occur when the camera is moved directly from a cold environment into heat. Wait for
the camera to acclimatize and the condensation will disappear.
– The camera hasn't been in use for an extended period of time and no battery was inserted.
Insert a fully charged battery.
Set the date and time.
– Does the battery have sufficient charge for camera operation?
Charge the battery or insert a charged battery.
– The system is currently transferring picture data to the memory card and the cache is full.
– The memory card is full and the cache is full.
Delete some pictures before taking new ones.
– No memory card is inserted and the cache is full.
– The memory card is write-protected or defective.
Deactivate the protection or insert another memory card.
– Image numbering has reached its limit.
Reset the image numbering.
– The sensor is overheating.
Allow the camera to cool down.
– Have you inserted a memory card?
– The memory card is full.
Delete some pictures before taking new ones.